VA BEACH MAX

[Anonymous]

Max,I need to ask you a favor.I Believe it was you that posted pictures of your sand scoop with a 90 degree angle on your long handle. I made the bottom part but missplaced the picture.If you could post a couple different angles of it again I could see the weld and finish it.I am going to put removeable handles on it so I can use it either way.Short or long.Thank you in advance.
Jim Pa

 

[Anonymous]

[No message]

 

[Anonymous]

<img src="http://www.mytreasurespot.com/spot/photos/beachcomberreview.jpg" alt="" />
<img src="http://www.mytreasurespot.com/spot/photos/ADDON.jpg" alt="" />

 

[Anonymous]

MAX,I HAVE SOME STAMPED STAINLESS LIKE YOU HAVE.I HAVE SOME 1/4 3/8 5/8 HOLES BUT WHEN I TRIED WORKING IT WITH A SMALL HANDLE THE SHOULDER DIDN'T RESPOND TOO WELL. I WENT TO A SEED STORE MY FRIEND OWNS AND GOT A NICE 7" WIDE SCOOP FROM HIM FOR $4. I CUT IT OUT ,LEFT THE THE SCOOP HEAD AND TWO SIDE SUPPORTS. I THEN WRAPPED 1/2" GALVANIZED SCREEN RIVETED WITH REGULAR RIVETS, NOT POP. IT IS REALLY STRONG I HAVE ALUMINUM 1 1/2"FLAT BAR SO I'LL WELD THE 90 DEGREE HANDLE TO THAT.THE HANDLES WILL COME FROM A WALKER OR ALUMINUM CRUTCHES I FOUND.THEN I'LL MAKE A SMALL HANDLE FROM THE CRUTCH TOP AND DRILL HOLES SO I CAN USE ANY ONE I WANT.THE SHOULDER PROBLEM IS TWO PRETTY BAD ROTATOR CUP TEARS AND CALCIUM SCRAPES I JUST HAD DONE,AND I SURE AND HECK AREN'T GOING TO MESS THAT UP AGAIN. GHOST ,MAX SAID YOU NEGOTIATED A BAD CONTRACT FOR HIM,SO I DON'T KNOW.WENT OUT TODAY FOR TWO HOURS TO TRY THE SHOULDER FOUND ALL NEW STUFF BUT THE SHOULDER WORKED OUT GOOD.THANKS AGAIN GUYS AND GOOD HUNTING.
JIM PA