Idea setting for smart plus

[IDB]

This is for the relic hunters. Where do you set your discrimination on the smart plus ?

 

[RG-DeepTech]

Hi, if you don't want to miss little things like earring, crosses and so on - disc on the red dot. But there are many users of this device here - so they can help too.
Here little movie about settings what can help. Otherwise many movies for this unit in Youtube. From Backwoodsdetectors - too.

 

[bigchuckinva]

This is for the relic hunters. Where do you set your discrimination on the smart plus ?

For Pure Relic Hunting Set Disc Level No higher then 2.5. Hunt in Two-Tone . Nails Will Give Low Tones at 2.- Preset Mark. If hunting area Lot Large Flat Iron. Set 2.5. Will Help I.D. Both Surface Large/Flat iron with Mix Low Tones and Slight High Tone "Click. Lastly, old trick I learned of all Deeptech i hunt with check Iron it Swing Coil different angles. 95 % Time if get High Tones swing coil different angles and give High Tone It good target Vs Get Low Tones

 

[IDB]

Thank you I’ve been setting mine way to high . I’ll try those settings next time I go.

 

[Richard@BackwoodsDetectors]

Disc. although it is iron only, it is very aggressive. A small non-ferrous target beside small iron could be missed if the disc. is too high... Relic hunting, use as little as possible.
I dig big iron anyway.. HH RR

 

[IDB]

Disc. although it is iron only, it is very aggressive. A small non-ferrous target beside small iron could be missed if the disc. is too high... Relic hunting, use as little as possible.
I dig big iron anyway.. HH RR

Thankyou wasn’t trying to ignore you I can use all the advice I can get