Find's Treasure Forums
Welcome to Find's Treasure Forums, Guests!
You are viewing this forums as a guest which limits you to read only status.
Only registered members may post stories, questions, classifieds, reply to other posts, contact other members using built in messaging and use many other features found on these forums.
Why not register and join us today? It's free! (We don't share your email addresses with anyone.) We keep email addresses of our users to protect them and others from bad people posting things they shouldn't.
Click here to register!
Need Support Help?
Cannot log in?, click here to have new password emailed to you
Changed email? Forgot to update your account with new email address? Need assistance with something else?, click here to go to Find's Support Form and fill out the form.
EMI and the xp deus 2
- Thread starter Waterdog
- Start date
Switch to a single frequency then adjust the sensitivity up/down until it stabilizes, then do a noise cancel. I have a couple of sites with fairly bad emi and either single frequency 13 or 17kHz with sensitivity between 90-95 works fine. Still might be a little chatter but a lot better than what you get in multi-frequency, and the good targets will still jump out.
DWerk
Well-known member
First thing is to discover what is causing the emi, where is it coming from.. Use the coil like an antenna, pointing the bottom of the coil all around you and locate the strongest signal area. Then start switching frequencies (still pointing the coil at the strongest signal area) until you find the frequency that gives you the lowest signal.