Crown Craps Advice needed for ANFIBIO.:sad:

[Sweeping-4-junk]

Today i took my newly acquired Anfibio out for the maiden voyage on my test site. A 45 minute hunt on a fair ground site. Detecting Mode 3 tone. 14 Khz . The hunt got off to a bad start with a nice sounding 88 VDI , this was dug and was a crown cap. The next few signals all sounded good high tones and were crown caps. also giving 88 VDI's , some of the crown craps were giving numbers in the 70 's. I dug 8 crown caps. A good sounding 21 was dug and was found to be a big foil clump, this gave an overload pinpoint signal though so i avoided digging this kind of signal after the first foil clump. A couple of 34 's were dug and were pull tabs. Ten minutes before leaving the site i got a solid 67 , this was a rusty £1 Coin with trash very close to it , missed probably by me on previous detecting tests here.
The Crown caps sounded so good especially the newer one's without rust on..The pinpoint button takes some finding . Pinpoint- a trigger switch would be much better than the tiny button switch. I had no choice but to dig the 88 VDI 's these could have been copper coins or silver coins or even a silver ring. So do you guys with the Anfibio dig crown caps also..This Detector is super hot on the trash!.

 

[The Digger]

If I'm in a heavily infested crown cap area, I use my concentric coil.

 

[bibelot]

set your tone break and tone volume for each tone sector so t clps the high tone from the low tone blend from the bottle caps.You can distinguish the difference quite easily this way.

 

[Doctorcoinz]

Thats the Coil i have ordered the 9 inch concentric. Mainly for Crown Crap reduction !!.. I know the 7 inch concentric has total rejection of crown caps but it's too small for my liking. I hope the 9 inch concentric will reduce or eliminate the crown cap menace. The concentric are great at pinpointing , fantastic to swing..