Find's Treasure Forums

Welcome to Find's Treasure Forums, Guests!

You are viewing this forums as a guest which limits you to read only status.

Only registered members may post stories, questions, classifieds, reply to other posts, contact other members using built in messaging and use many other features found on these forums.

Why not register and join us today? It's free! (We don't share your email addresses with anyone.) We keep email addresses of our users to protect them and others from bad people posting things they shouldn't.

Click here to register!



Need Support Help?

Cannot log in?, click here to have new password emailed to you

Changed email? Forgot to update your account with new email address? Need assistance with something else?, click here to go to Find's Support Form and fill out the form.

Back to the future part 2. Tried this yesterday and it got lost in transit

I dont' understand what you mean by pull off..effect/......Do you mean it didn't detect the nickel, or detected it better?
 
Pull off effect.

Let's say you are standing in a field with no targets in the ground except a small paint can lid that is 8 inches deep. The lid has rusted around the outer edges so that it is an irregular sawtooth pattern. On most VLF machines as you swing towards the lid the tone ID will chirp high tone and the audio response will be ratty sounding. As your swing continues over the lid and centers on it the detector should null(go silent) if you have iron Disc'd out. As you continue your swing passing the outer edge there will be a slight delay as the detector comes out of that null and chirps a high tone. That delay effect is what I call Pull off.
 
BB said:
With the X70 in Prospecting All Metal mode & GB'd to the surrounding soil the rock nulled over dead center but gave an Iron edge like pull-off tone on either side of the rock. I then switched Tracking ON to see if it would have any effect, and it did, the pull off tone was reduced to about 25% of the original after a couple sweeps.

bubber said:
[size=medium]I dont' understand what you mean by pull off..effect/......Do you mean it didn't detect the nickel, or detected it better?[/size]

Bubber what Bill is describing is the effect of a 'cold rock'. Hot rocks give a response like a valid target while cold rocks due to their particular type of mineral content, signal on the approach and departure of the coil and null over the center. This is sometimes described as a 'boing type of sound' response.

Using all metal mode smaller cold rocks will allow targets to be heard when on top of or under the rock. Hot rock responses can be lessened with proper ground balancing but doing so will also reduce the response of valild targets. Most hot rocks that give a response are located on or near the surface and easy to ID by sight.

Tom
 
The bottom line for me is that Tracking is good. Use care though, not to track out a target, because of to many passes or to much sensitivity.

When I do not dig the Boing target I feel I may have left something benind. You can not rush expierence.

Jeff
 
Very interesting test, I have not fiddled much with the IM in prospect but the more I hear good results the more interested I am in using it. I typically hunt in All Metal in daylight and prospect at night, switching to AM for ID. I think I will try a hunt where only 10 thru 26 is accepted at night but probably will have too many nulls, maybe prospect and then switch to C & J with 10-26 accept as I waste too much time digging pennies and we have almost no old silver where I am. For those of you who do not use All Metal you are undoubtedly missing some good targets, I hunt school playgrounds that have been pounded and am able to pick up coins n stuff next to iron that others miss. If you only hunt C & J you will not hear these targets.
 
Top