Anybody Ever Try This???

[silverseeker 2]

Just curious if anybody on the Forum here has ever made
a Splitter or Pigtail so you could run 2 coils Side by Side?
Is it even Possible to do this or would it drain the detectors
Power so the Detector would not run or perform right?
Curiosity got me Pondering... I know, Curiosity killed the cat
silverseeker 2

 

[MuddyMo]

Most coils by themselves weigh more than I want to swing.

 

[BigTony]

Just curious if anybody on the Forum here has ever made
a Splitter or Pigtail so you could run 2 coils Side by Side?
Is it even Possible to do this or would it drain the detectors
Power so the Detector would not run or perform right?
Curiosity got me Pondering... I know, Curiosity killed the cat
silverseeker 2

I want the large 11 inch coil to have a six inch center coil and a bush bottom on the detector face to toggle between the two.
Also, a very small coil in the exact center for the pin pointer!
Oh one more thing, I want to talk to the machine to make settings changes, instead of looking through the menus for me to fat finger something.
Tony NJ

 

[Wild Willy]

Heck, at my age I can hardly swing one coil. But I "keep on keeping on.".

 

[BigTony]

Heck, at my age I can hardly swing one coil. But I "keep on keeping on.".

That is One reason why I tried the Deus 2 -

 

[oldkoot]

Just curious if anybody on the Forum here has ever made
a Splitter or Pigtail so you could run 2 coils Side by Side?
Is it even Possible to do this or would it drain the detectors
Power so the Detector would not run or perform right?
Curiosity got me Pondering... I know, Curiosity killed the cat
silverseeker 2

Nexus Metal detectors has some coils as you describe their largest coil in that configuration is Dual 31inch coils side by side two 31 inch coils, could not even imagine trying to swing a coil that large, would have to use a detecting harness for sure to be able to swing something that big, if I remember correctly it runs 5.7 KHz

here you go scroll down until you get to the coils

Nexus Standard MP V3 Induction Balance metal detector.

Nexus Standard MP V3 - Version 3 Induction Balance metal detector.

www.nexusdetectors.com

 

[Rick(ND)]

You know when SunRay made the pin pointers they had the right idea as the probe was a actual 1 inch coil. Now if you disconnect the probe from the switching control box and added a smaller coil on a old extra shaft you would have it. the toggle switch one way would be the main coil and flip the switch to pinpoint and you would have the smaller coil, when done you switch back to the main coil. Now the extra coil could be carried on your belt when you need it so you just flip the switch and that will shut off the main coil and now connect the smaller coil as it would have have the extra rod connected to it or even make and shaft. It may be slightly clumby, but sure be better than trying to swing both coils at one time.

Rick