Menu
What's new
Find's Treasure Forums

Welcome to Find's Treasure Forums, Guests!

You are viewing this forums as a guest which limits you to read only status.

Only registered members may post stories, questions, classifieds, reply to other posts, contact other members using built in messaging and use many other features found on these forums.

Why not register and join us today? It's free! (We don't share your email addresses with anyone.) We keep email addresses of our users to protect them and others from bad people posting things they shouldn't.

Click here to register!

Need Support Help?

Cannot log in?, click here to have new password emailed to you

Changed email? Forgot to update your account with new email address? Need assistance with something else?, click here to go to Find's Support Form and fill out the form.

Ace 250 trigger pinpoint mod and 250/150 stand mod

Hi Kenny,tried the two points that are shown but it did not work.The point where the green wire is shown is good but the other is not,had to open switch for the other contact.I guess there is some circuit variations,along the way/years.I tried to find the point with a ohm meter but there was none to be had,so had to run small wire soldered from the outside sw contact..Do you know of any circuit board changes?I like the sw very much.Thanks again. Joe B
 
Joe B,
The picture is one a fellow electronic tinkerer sent me. He assured me that these contacts were the ones he used on his switch mod. I never tested it. I guess I should have. I felt this would be easier to perform so I posted the picture. My personal mod was opening up the switch. Scraping off the graphite on the contacts and soldering the wires there. This may be frightening to do for some? But it now looks like it may be the only way... I'm sorry for anyone that had tried to perform the mod using the incorrect points in the picture.
 
You must log in or register to reply here.
Top