Mike Hillis
Well-known member
I haven't had my Eurotek Pro out in a long time so I though I'd take it for a spin this past weekend for a couple of hours for a walk about.
Had the iron volume on 11, Disc on 35, Sensitivity on 7.
I run the disc at 35 because the ferrous/non ferrous range on the ETP is very soft....a lot of small non-ferrous will hit right at 38 through 40.
I'm swinging away digging high tone clad and any middle range VCO tone that I like the numbers of when I got a nice little light 40 VCO that buzzes in and out of volume. Remember Volume setting of 11 puts the ferrous volume at its lowest level (0 to 39 TID) and 40 and up is the regular full tone non-ferrous. This was buzzing in and out of both audio volume settings (low iron/normal non-ferrous).
Turned out to be a 1.4 grams of 10k gold bracelet on the surface down in the grass roots. Looks like a link broke and the poor guy lost it and a pirate found it...>ARRRG
It was a good day.
HH
Mike
Had the iron volume on 11, Disc on 35, Sensitivity on 7.
I run the disc at 35 because the ferrous/non ferrous range on the ETP is very soft....a lot of small non-ferrous will hit right at 38 through 40.
I'm swinging away digging high tone clad and any middle range VCO tone that I like the numbers of when I got a nice little light 40 VCO that buzzes in and out of volume. Remember Volume setting of 11 puts the ferrous volume at its lowest level (0 to 39 TID) and 40 and up is the regular full tone non-ferrous. This was buzzing in and out of both audio volume settings (low iron/normal non-ferrous).
Turned out to be a 1.4 grams of 10k gold bracelet on the surface down in the grass roots. Looks like a link broke and the poor guy lost it and a pirate found it...>ARRRG
It was a good day.
HH
Mike
