X70 pinpoint question

[oldcellar]

When I am pinpointing with my machine the display almost always shows a negative number. Then it hits on good signal again once I release pinpoint. Possibly gargage near something good? I'll take all opinions to try to help me understand what is going on here.

 

[Monte]

The X-Terra's are different from most makes/models that require you hold a toggle or button in a momentary-shift position. Press into Pinpoint and then release. Problem solved?!?

Monte

 

[oldcellar]

Does my unit show target ID during pinpoint, and can it change during pipoint as it does during a search mode? I have read the manual and it does not specify this....

 

[Kelley (Texas)]

while in the Pin Point mode...the visual numerical I.D. will still I.D. targets. Yes the numerical value can change if you place the coil over a different target than the one originally pin pointing for.

I would like to note that my X-Terra 30, unlike my X-Terra 70, will not continue to visual I.D. while in the Pin Point mode. Kelley (Texas)

 

[oldcellar]

Thank you all ...you are very helpful. I can't believe how different, both with a lot of positives, my Exp II and X-70 are.