WOT Question

[Anonymous]

Having some trouble pinpointing. How do you tell the difference between a hit from the WOT rim and the center strip. I'd appreciate any tips on its use. Thanks

 

[Anonymous]

The center stip will be hotter from my experience with even the stock coil, so I will lift up the coil a little and pinpoint the target so the edges will not pick it up.
With the WOT I can also tip the coil up so the tip is only on the ground and pinpoint too.
Rick

 

[Anonymous]

Rick,
Even with the stock coil I used to have lot of trouble with rusty iron. When operating with the iron mask at -14, rusty iron would null over the center strip but indicate a diggable targer a few inches away. But I could find the target in the hole using the X1 probe. I would just scratch my head and wonder what was going on.
After figuring this behavior out, I started quickly switching to pin point mode. This allows me to determine that the target was really a few inches away from where I thought it was. This seems to work well, but I think your suggestion may be an easier technique to use.
HH, Glenn

 

[Anonymous]

Use PP and u will find that the loudest point is right under the little guy even on deepones hope that helps

 

[Anonymous]

Dave,
Thanks. My problem is mostly due to geting three hits from the same target, (left rim, center strip, right rim). Does PP provide a cone-shaped pattern instead of the double-D?

 

[Anonymous]

Thanks Rick. I give it a try.
Kestrel