W.O.T on Excal II??????

[southernstyle]

So I just got my W.O.T coil and have wired it accordingly.....however it does not seem to be operating properly. Any help would be great. Here is what I was told. The four wires coming out of the unit should be hooked up like this....Red wire to pin 1, Black wire to pin 2, Yellow tho pin 3 and White to pin four. This is for the connectors that came with the W.O.T. I have hooked my 10 inch stock coil and it works fine. So I pulled back the connector on the W.O.T that comes pre-wire. It goes as follows. Red wire pin 1, Black wire pin 2, White wire pin 3 and Orange wire pin 4.

HELP

Chris
Cayman Islands

 

[southernstyle]

Never mind. The guys from Coiltech got right back with me and let me know the wires on the W.O.T actually were reversed. So for anybody else that may run into same problem. Just de-solder the Orange and White wires from the W.O.T and reverse them. Works great. Making me a straight shaft for the new weapon added to the arsenal. Can't wait to try it out tomorrow am.


Chris
Cayman Islands

 

[Finderskeeper]

The WOT is super sensitive in the waves near the edge. When in the water, it is a gem. But at the waters edge, it is a bit touchy and I have to adjust the sensitivity down a bit to keep it from falsing.

I have found the WOT is great in the dry sand. I would not go back to the tiny 10 factory coil after using the WOT.

 

[OldBeechnut]

Good Reading on the WOT, By CJC ......and .....bbsailor .....................about using the sovereign/excalibur Almetal hunting

http://www.findmall.com/read.php?21,290025,293707#msg-293707

[size=large]How was the trip to florida, SS?[/size]

 

[Neil]

n/t