User Profile

[Architex]

I have noticed that when I set up a user profile with disc settings (certain numbers blanked out) and save it, and then switch to a factory setting then back to the profile, the disc pattern does not show up. Is that normal or am I suffering brain flatulence?

 

[IDXMonster]

This is what I see with the CTX if I use the same Mode for all dat...switching to the factory Mode wipes it out. Not sure about the EQ though...

 

[Tom Slick]

I'm not sure but I think I read that if you turn the detector off while in a user mode, it will erase the settings. I think you have to remember to switch to another factory mode before turning off the detector in order to have the settings saved.

 

[tometusns]

No, that's not normal. The user profile should retain the settings that you had on it.

 

[tometusns]

Just a thought, are you holding the save button in long enough for it to lock it in as saved?

 

[Architex]

Just a thought, are you holding the save button in long enough for it to lock it in as saved?

Yes, doing everything by the book. So I assume that not showing the disc pattern is not normal?

 

[tometusns]

Just a thought, are you holding the save button in long enough for it to lock it in as saved?

Yes, doing everything by the book. So I assume that not showing the disc pattern is not normal?

Yes, you are correct. It should retain the disc pattern.

 

[tometusns]

Just another thought. Try doing a factory reset and see what happens. Good luck!

 

[Architex]

All is ood. Did it the same way as last time and now it works. (obviously NOT the same way as last time - LOL). No reset necessary.