Most of the time over the years I have been detecting I have built those tools etc needed to make the task of searching and recovery easier.
Sometimes though it makes sense to go with equipment that is available, rather than spend time and effort "re-inventing the wheel".
I wanted a smaller scoop than the one I have been using for so many years to have smaller loads to lift and allow me to hunt longer without getting exhausted.
I saw this scoop mentioned on another forum as available on E-Bay and ordered one as it looked like a great buy.
[attachment 201131 PoorMansBack-HoeScoop018Large.jpg]
It is well made of sturdy materials and at $99.00 the price was right.
[attachment 201132 PoorMansBack-HoeScoop021Large.jpg]
It is of 14Ga. S/S, 7 inches wide, 6 inches high, and 10 inches deep at just over 3 lbs. (The heavy duty handle brings it up to just about 71/2 lbs.)
I preferred an aluminum handle to the wood handle it was built to use and removed the one I had installed on one of my recent creations.
After carefully aligning the handle and wedging it into place I epoxied it into place and when the epoxy set I drilled holes for two stainless steel bolts although I doubt if the epoxy would ever fail.
[attachment 201134 PoorMansBack-HoeScoop024Large.jpg]
Today is a lousy day for hunting with a northerly breeze, rain and temps in the fifties.
I
Sometimes though it makes sense to go with equipment that is available, rather than spend time and effort "re-inventing the wheel".
I wanted a smaller scoop than the one I have been using for so many years to have smaller loads to lift and allow me to hunt longer without getting exhausted.
I saw this scoop mentioned on another forum as available on E-Bay and ordered one as it looked like a great buy.
[attachment 201131 PoorMansBack-HoeScoop018Large.jpg]
It is well made of sturdy materials and at $99.00 the price was right.
[attachment 201132 PoorMansBack-HoeScoop021Large.jpg]
It is of 14Ga. S/S, 7 inches wide, 6 inches high, and 10 inches deep at just over 3 lbs. (The heavy duty handle brings it up to just about 71/2 lbs.)
I preferred an aluminum handle to the wood handle it was built to use and removed the one I had installed on one of my recent creations.
After carefully aligning the handle and wedging it into place I epoxied it into place and when the epoxy set I drilled holes for two stainless steel bolts although I doubt if the epoxy would ever fail.
[attachment 201134 PoorMansBack-HoeScoop024Large.jpg]
Today is a lousy day for hunting with a northerly breeze, rain and temps in the fifties.
I