Tracking Notes

[Rob (IL)]

Tracking

All right we covered the correct way to ground balance the V3i. Now that the detector has filtered out the ground signal we need to maintain that balance using the tracking options. Those two options would be Autotrac or LockTrac.

A proper GB should really be done before the AutoTrac is used to maintain that GB. AutoTrac does this by keeping pace with the changes in the ground and then adjusting the set point to match the change. The V3i AutoTrac system will eventually get you to that point if you don't ground balance. However, the further off you are, the longer it will take.

There are some settings to consider. I would make sure you have Inhibit - ON, so you won't track out a weak target when you make multiple passes over it. It is defaulted on so that the machine doesn't track when it sees a target. You don

 

[mickfin]

Rob iL, Good wrighting, Dos the VX3 have those settings what dos it Lack Vs the V3i???? Thanks Rob, Mickfin

 

[Larry (IL)]

I thought we posted this once before for you but here it is again...... Differences between the V3i and the VX3:

http://www.findmall.com/read.php?66,1497249

 

[Rob (IL)]

The answer would be NO. Here is pretty much what you can adjust.
[attachment 205208 2011-07-23_144056.jpg]

 

[mickfin]

Thanks Roc iL , Mickfin i got one on order,