Heard a lot of good things about the F70 so I took the plunge and got one. I do not believe I have ever purchased a detector that has been this bad. I have a test garden with coins and typical trash you may find at a local park or school. I buried them all at 6 inches. I also buried a silver quarter at 10 inches. The CZ3D I have will ID all the targets correctly. The F70's id numbers jump around so bad on every target it is unbelievable. I dug up one target, a zinc penny and the reburied it at 4 inches. The numbers jumped around from low to high even at only 4 inches. It will not even see the quarter no matter how high the sens. I have tried many different settings and combination of settings to no avail. I have reset the unit many times. It will GB at 62 which I do not believe is that bad. I took it outside today just to play around with it a little more before I sold or traded it and the display went crazy and eventually faded to nothing. I do not believe it is electrical interfernece because I live out in the middle of nowhere and I am the only house around for a quarter of a mile. I have replaced the batteries, reset it numerous times. It will work for a little while after it sits but goes right back to the messed up screen. I am hoping fisher will make it right on this one. I have to believe I got a dud, surely no company would put out junk like this. you can see in the picture how the screen has faded and it has notched out certain items all by itself. Sorry but just had to vent.....