Hey, just a note to thank you guys for the discussion,even though it was a misunderstanding. I have a Silver umax and I added a switch similar to the one on the late Troy detector(coin check) It in essence turned my Silver into a Tejon without the GB feature. Now I didn't have the proper resistor ( the long one with the adjustable screw to set the disc level),so I soldered a hundred ohm fixed with a variable 50 ohm ( I had calculated by the position on the disc dial that tabs were in around 120-150 ohms). Since I didn't have to solder directly to the board, I felt relatively safe in doing this. Still, I used heat shields just to allow for my inexperience. The point is this: I am a slave to ID and I think I must have the Golden as I want a detector that I can unfold and place on my bicycle and carry w/me and yet have every option necessary in case I run into a trashy site. Thru all ya'lls posts, I learned how to do it, the correct settings and how to adjust the tones and with what objects to use to adjust them. It all turned out for the good. And I guess I'll just keep my slightly altered Silver.