So your detecting along and get a 12.44 move to center target it reads junk.False you think not so fast go back where you hit the 12.44 this coin is hitting on the leading edge of the coil as you move forward to center the coin becomes junk. But if you go back and hit the 12.44 and hold pinpoint with target trace you well see the 12.44 fill the cursor at the dime spot as you move forward the iron cursor also fills now you have 2 cursors filled 1 iron 1 at 12.44 . This means you were drawn to the lets say bottle cap being the iron and said dime is 2 inches away .Now your 6 inches off of the original hit making you think false but you have the 2 cursors filled.So go back to where you hit the 12.44 with the tip of the coil and engage pinpoint target trace and center the target with the leading edge of the coil and dig. To verify put a bottle cap 2 inches away from a dime with the leading edge of the coil hit the dime 12.44 as you center the hit the bottle cap pulls you away from the dime and the target trace splatters not showing the dime another words a junk signal from all ways.But with pinpoint target trace engaged and holding the button in all the time as you hit your 12.44 the dime cursor well fill as you move forward to center still holding pinpoint target trace button The iron cursor well fill. This means your over the cap because it is larger and pulling you away from the dime.Most people hit the dime and move forward to pinpoint and end up being 6 inches away from the dime and then get the junk signal and never see the dime that's right there.Target trace has to be engaged and held as you hit the coin with the leading edge of the coil or you well only fill the iron cursor.If you release the button on the pinpoint target trace at anytime the dime well disappear .This also works with pull tabs and other hits As far as nails say a 16 penny nail over a dime it well read 12.44 one way and cursor well fill and great audio but if you swing the other way it well be junk with splattering on the cursor.If you engage the target trace on the nail the cursor on the dime well fill and the iron cursor well fill but the dime well fill as 12,33 because the nail is pulling the #s down also there well be no audio high tone just grunts but you have both cursors filled and a nonferrous target at 12.33 which is a dig in my book I think i confused myself anybody else notice anything about target trace.Thankx sube