Support for older CZs

[Clad2Hunt]

Just wondering if anyone has had to have a repair done on a early 90' model CZ. I was wondering if they are still supported? Trying to hold out for a 3D but their are a few used ones out there.

 

[cometguy]

I talked to Fisher yesterday about a CZ70 pro. What they said makes sense to me. "Parts may be in short supply or not available for some problems". Fisher is more than willing to take a look, and fix the machines they can fix. Many times small problems are calibration issues.
The techs can calibrate and adjust settings in the CZs. The nice thing is that they are built like a tank. An awful lot of old CZs are still doing what they were made to do. I would say, "buy carefully". Try to get a machine you know is working 100 percent. Remember to call Fisher before you send any detector in to be repaired. I talked to a tech yesterday about my machine.

Don
HH

 

[Clad2Hunt]

Thanks Don Any unit I would get would be from on line so no chance to test first.

 

[ElginTim]

Seems like board-level issues should be no problem for them. They still make the CZ-21 and I've read it's the same old guts. Housings, control interfaces, etc. seems these may become problematic at some point.