Ok, here's the challenge. I am about to get an X-1 probe, however, I don't like the coil cable snaked around my sleek lookin' mean machine. I like the clean look and not worry about snagging cable on brush. Mike has a mod I was considering (please repost pic Mike), but is the end of the probe that connects to the control head mounted internally in the new upper shaft? Also, digger had an idea about creating a new plug (please repost HonoverDigger)to help route the cable, but I was wondering if this would make it too difficult to coils. Please post your ideas for modding this setup to keep wires internal and with ease of access.
Thanks,
Travis
Thanks,
Travis