Strange VID on F75 :confused:

[damiano]

Hi,
Last time when i use my F75 i see strange VID on the screen - there is no numbers on LCD but only + (plus) indicator.
I wored in AMM and dig deep hole (yellow sand-inside land-GB about 68-75) about 30-32 inches (when i get shallow targets i have more and more signals from iron little pieces-too bad i don't find nothing special).

Have anyone that VID ??
Is this mineralization or ground signal ??

 

[Elton]

Remember the ID, and the Audio are total separate entities on the F75.. It Id's audio sounds much deeper than Visual Target ID on your screen.
Sounds like you hit a pocket of Dumped Iron.Or, something that broke up over the years in the ground and you found the remnants.

 

[zaxfire69]

The + sign is the Overload sign. Hey Elton, I have been getting a few hits that will sound off in the headphones, but won't have a number on the VDI. Should I dig these targets or do they usually mean just a trash target?

 

[Cal_Cobra]

Hey Elton, I have been getting a few hits that will sound off in the headphones, but won't have a number on the VDI. Should I dig these targets or do they usually mean just a trash target?

Target audio and target VDI are processed separately and as such it's possible to get a deep target that sounds off but is too deep for the VDI system to work. Double check the target in AM mode.

 

[Elton]

But most of the time it is a piece of scrap metal..bunched up, or a piece of old 60's pulltab.dig a few see what they are..then if it's junk don't dig any more in that specific area

 

[Cal_Cobra]

But most of the time it is a piece of scrap metal..bunched up, or a piece of old 60's pulltab.dig a few see what they are..then if it's junk don't dig any more in that specific area

I never claimed to find anything good, but valid targets yes

....I'm still learning, it's getting easier and easier to ID trash as I learn this trick on this machine and that trick on that machine, BUT there's still plenty that gets by, or I dig it because it sounds "interesting"