Standard Audio Tones ?

[a.c.t.i.v.8]

Is there any where that tells us what the standard audio tones are ? What I mean here is, what say C&J Audio is set up as ?? I can see we can have either shifted or custom set up's but would like to know how the standard is set up ??


Dave

 

[Rob (IL)]

There are 191 VDIs, each can be assigned a tone. The 'standard' tone setup is to start with tone 65 at VDI=-95 and increment the tone with each VDI up to tone 255 at VDI=+95. But who cares. Set up the tones you like and then use the common program so all your programs are the same. Rob

 

[a.c.t.i.v.8]

Thanks Rob but that is what I have done with the COMMON program. So am I correct in thinking that from -95 set at 65 every VDI number after goes up 1 ?? Does sound right Rob....

 

[Larry (IL)]

I believe in Tone ID Mode-Custom........it shows you what each VDI # is assigned what audio frequency. I don't know right off hand if it is a single Hertz increment as the scale increases, but I think it is close if not. That is also where you can assign what tones you desire for certain VDI's or blocks of VDI's.

 

[The Beep Goes On]

Here are the standard tones by program (Tone Range 14 for Mixed Mode Pro is '100<-->100'...cut the image off by accident).

 

[TheMarshall]

Sod the tones.....How did the rally go?

 

[a.c.t.i.v.8]

Sod the tones.....How did the rally go?

Ha ha ha brilliant !! Went ok, half a dozen roman coins but was hard going .... Tell you some thing, the Romans must have been clumsey as they lost all their coins !!

 

[TheMarshall]

Where was it located..I hope it wasn't near Marbury I