Find's Treasure Forums

Welcome to Find's Treasure Forums, Guests!

You are viewing this forums as a guest which limits you to read only status.

Only registered members may post stories, questions, classifieds, reply to other posts, contact other members using built in messaging and use many other features found on these forums.

Why not register and join us today? It's free! (We don't share your email addresses with anyone.) We keep email addresses of our users to protect them and others from bad people posting things they shouldn't.

Click here to register!



Need Support Help?

Cannot log in?, click here to have new password emailed to you

Changed email? Forgot to update your account with new email address? Need assistance with something else?, click here to go to Find's Support Form and fill out the form.

Shallow Water

Flying Pig

New member
I see there are numerous posts on using the V3i at the beach, but I am wondering who ventures into shallow water with it? Risks? Rewards? Curious....thx
 
One slip and dunk can't balance any rewards. Of course people do what they want.[attachment 229885 cop.gif]
 
I have hunted in water a foot deep without too much worry, anything more than that is probably not worth the risk to me.
 
Thank you both....I may be going to a small lake shore tomorrow night and will approach this thought very carefully!
FP
 
As long a you are standing up all is fine in a foot or two of water. It's if you lose your footing when the trouble starts. Also if you do try the shallow water make sure you don't raise the coil higher than the box. Water can run down the tube and into the electronics.
 
You find water hunting very productive if looking for rings and jewellery ,good to have water scupe for easy recovery.
 
Creeks and small streams are fine but careful with slippery rocks. Ocean beaches are a little more risky. I have heard of people getting hit by a large wave when they have their back turned. Also the salt air is something to be concerned with. Make sure you wash the coil and rods, and wipe the pod and control box down with a damp cloth.
 
You can't waterproof it, but you can sure cut down on the potential damage by enclosing the entire control box/screen in a clear plastic bag. Use rubber bands to pinch off the holes where the detector shaft and coil wires exit the controls. It won't stop potential damage, but it'll give you a few extra seconds to get the machine out of the water before the water reaches the electronics.
 
Top