Find's Treasure Forums

Welcome to Find's Treasure Forums, Guests!

You are viewing this forums as a guest which limits you to read only status.

Only registered members may post stories, questions, classifieds, reply to other posts, contact other members using built in messaging and use many other features found on these forums.

Why not register and join us today? It's free! (We don't share your email addresses with anyone.) We keep email addresses of our users to protect them and others from bad people posting things they shouldn't.

Click here to register!



Need Support Help?

Cannot log in?, click here to have new password emailed to you

Changed email? Forgot to update your account with new email address? Need assistance with something else?, click here to go to Find's Support Form and fill out the form.

SE Pro and various tones

JoeinMemphis

Active member
Hello, I am new to the SE Pro, and am hunting in a very iron polluted area. each swing brings about 5 nulls. Occasionally the null also has a higher tone mixed in with it (with the machine set to ferrous sounds) I was wondering what the chance is of it being multiple iron targets fooling the machine or "adding up" to a good target, or is there usually something actually non ferrous down there? Any input would be greatly appreciated. HH Joe
 
By walking around the target with a short fast wiggle, you can usually isolate the target in the trash, (iron). I use Ferrous tone, IM -31 and smart screen. If the cursor goes to the top of the display, especially top right, I dig. The high tone could also be rusty iron or steel, or chunks of lead, (including bullets), but the cursor will go to the lower right for rust and mid right for lead. By outlining your target while in pin point mode, you can tell if your target is a round coin sized object as well.

The best way to learn your machine is to dig all suspected good targets and learn first hand what causes it to do what it does. A smaller coil in that much iron will help tremendously too.
 
n/t
 
Larry's answer is really good, also you should notice the amount of high tone you are getting. A lot of them should be just momentary chirps which is nails falsing. Circleing the signal will tell you how iffy it is.
Watch your depth meter, if it is showing shallow you know to trust your meter more.
The amount of high tone you are getting in the mix is important, if you get a better sounding warble in iron then it may be worth investigating. Dig some of those you have in question and try to remember the depth reading, how much high tone coming thru and if you are getting any meter reading that gives you a hint that it may be a non-ferrous item in the mix. The more you dig iffies, the better you will get at interpreting which to dig or pass on.
HH
 
There was one last weekend that stands out, iron then multiple tones from all directions. Yup, I probably left an 1851 Navy in the ground :rage: HH Joe
 
Top