Menu
What's new
Find's Treasure Forums

Welcome to Find's Treasure Forums, Guests!

You are viewing this forums as a guest which limits you to read only status.

Only registered members may post stories, questions, classifieds, reply to other posts, contact other members using built in messaging and use many other features found on these forums.

Why not register and join us today? It's free! (We don't share your email addresses with anyone.) We keep email addresses of our users to protect them and others from bad people posting things they shouldn't.

Click here to register!

Need Support Help?

Cannot log in?, click here to have new password emailed to you

Changed email? Forgot to update your account with new email address? Need assistance with something else?, click here to go to Find's Support Form and fill out the form.

Screen analyse problem?

C

cypearl

Member
Learning the detector i discovered now want it to be fast that when I just change the screen to analyze the target as I have polar plot for that when hunting with the trigger i found out that sometimes is not responding at all in polar plot as it s just the big cross on screen and without showing the colored looping lines with it. The other thing when at normal hunting i ve got the sizing screen 'trigger in middle' it is not changing from target to target especially in trashy areas and i have to press the trigger to pin point and release to show the next target. It is not the same with sounds of course since I can hear all of them around. Can you help with this please I ll appreciate that. Thank you very much in advance.
 
I'm having trouble understanding what you are asking.

But, The Analyze Screen needs to have a period of time of no targets before and after seeing a target. So wait, thousand one, thousand two before sweeping the target and before re-sweeping the target. Pinpoint the target before analyzing. Off center sweeps can cause anomalous patterns.
Settings that are too hot can cause anomalous patterns or no patterns. Having your settings too hot may cause the analysis graph to trigger on ground. If there is enough noise to be triggering it within that required quiet time, then it cannot trigger to display the signal, or it triggers later and shows the wrong data. . If your noise source has signals that are as large as your deep targets, you will not be able to see a good reading either.
 
Thank you. I will try that. But is it the same and for trigger to be in middle to be that late from target to target cause I experienced also that today Rob?
 
I'm trying to understand what you are asking. Where is your recovery delay set? What is the Spectragraph fade set at?
 
Thanks Rob.I meant exactly the time is processing the target from first to the next! where is the fading rate adjust ?
 
The time for processing the target information is recovery delay. The time the information is on the screen is fade.

Fade is found in the expert menu > configure > spectragraph > fade. I think it was defaulted at 10.
 
You must log in or register to reply here.
Top