safari question beach hunting

[croakersmoker78]

Hello i am having problems in the sand i will get a hit say 37 and than it will hit at 37 for everything. I take off the cover and clean it and dry it and it is OK but than it goes back to it. I just want to know if it is the water in the cover that is doing it should I remove it. Is anyone else getting this it works great in the grass and dirt only when it is wet and in sand. THANKS

 

[Qu]

After each days of hunting remove your coil cover and clean it,after a while the Small rock stock in the cover get magnetize.Water is not the problem.

 

[croakersmoker78]

yes but i clean it all day long and still get alot of signals all over the numbers why would that be only in the sand and after it is wet

 

[Qu]

What sensitivity you are using,try lower sensitivity.If the problem continue maybe you have a bad coil.

 

[Sky1]

That happened to me at North Myrtle Beach. Was the first time I had ever seen it. I think mine was an 11 though.
I took the cover off and rinsed it but had the same issue.
Not sure what was causing it, I just ignored it as it was easy to determine that it was not a real signal.

 

[diggitdawg]

here in long beach ca. there seems to be a lot of black sands on the beach. when i beep at the beach i just leave my cover off then i dont have to worry about all the little particles of ??? staying in there & scraping around. the sand gets in there anyway so the protection from the cover is minimal imo. good luck out there