dirt lizard
Member
Is there a way to stop the bracket from moving around the part that's attached to the meter or do I have to get a new bracket ?
Find's Treasure Forums
Welcome to Find's Treasure Forums, Guests!
You are viewing this forums as a guest which limits you to read only status.
Only registered members may post stories, questions, classifieds, reply to other posts, contact other members using built in messaging and use many other features found on these forums.
Why not register and join us today? It's free! (We don't share your email addresses with anyone.) We keep email addresses of our users to protect them and others from bad people posting things they shouldn't.
Click here to register!
Need Support Help?
Cannot log in?, click here to have new password emailed to you
Changed email? Forgot to update your account with new email address? Need assistance with something else?, click here to go to Find's Support Form and fill out the form.
Rons 180 meter bracket
- Thread starter dirt lizard
- Start date
GeorgeinSC
Well-known member
Do you mean moving around the shaft??? I put a piece or two of paper between the shaft and the bracket to tighten it up just a little as the bracket will mover around the shaft after it gets a little age on it.
dirt lizard
Member
It's the bracket screwed into the back of the meter is wobbly
On the mount clamp use 1/2 inch shrink tape.Take the thumb screws off and cut enough shrink tube to cover the bottom bracket mount the same for the top mount sides this should fix your problem.On the bracket stem itself if the user bends the meter back sometimes this will make the shaft loose a temp fix to fix the problem,five minute expoxy.PM me your address and I'll send you a new bracket and screws no cost.HH Ron
dirt lizard
Member
Thanks Ron