Menu
What's new
Find's Treasure Forums

Welcome to Find's Treasure Forums, Guests!

You are viewing this forums as a guest which limits you to read only status.

Only registered members may post stories, questions, classifieds, reply to other posts, contact other members using built in messaging and use many other features found on these forums.

Why not register and join us today? It's free! (We don't share your email addresses with anyone.) We keep email addresses of our users to protect them and others from bad people posting things they shouldn't.

Click here to register!

Need Support Help?

Cannot log in?, click here to have new password emailed to you

Question

D

Dean (Whitby Canada)

New member
The first time I take my T2 out, just to try, what should my settings be?? I hunt for relics.

Dean
 
Paul(Ca) posted this for me once

Hi Jeff,
I have the T-2 and the unit does extremely well in sites full of iron, I use these settings.

Disc mode,
Tones set at 2+,
zero discrimination,
Sensitivity level very low,
,Use the quick grab GB mode in the cleaner patches of ground.
 
Thank you. Really looking forward to getting this beast!!!

Dean
 
Jeff Question
I have not bought the T2 yet. But am getting as much info.as I can.
You told dean that you use the 2+ tone in you set up. Why? and what
is the diff. from four tone?
diggercoins67 Thanks you and every bodyeles on
this forum.
 
I told Dean that as was pointed out before for relic hunting it is basically good or bad on the tone ID. Anything above a low tone is acceptable and therefore two tone will do the job. Mr Bill and or Paul(ca) had posted something else about that but I cannot remember what it was. Hopefully they will come in and add to this.
Sorry I took so long to give you such a crappy answer. We are going nutz here with orders, spring is arriving!!!!!!!!!!
 
Hi Jeff

Was this what you were referring to ??

If your going to hunt in a trashy area it would be best to use 1, and 1+, because it doesn't average out the target response.

I'm not certain if using 2+ will allow this same affect, or it will take a average, and report it as such.

I haven't had any time, nor has the weather cooperated to use the unit lately.

Mr. Bill
 
Bill from what I have experienced thus far the T2 will up-average at any/all tone settings especially when it hits on a non-ferrous metal that is in close proximity to iron just as the manual states. The numeric increase I have seen range from 2-6points, though had one occasion where it did read higher than that...though I wouldn't swear to it that it was caused by up-averaging.
 
Jeff
Thanks. And the A. was not Crappy to me as I am just trying to
get all the info. I can get. Glad your Bizzy.
Diggercoins67-Don
 
You must log in or register to reply here.
Top