Pattern i have been using

[sube]

[/img] My biggest problem is all the high tone falsing that happens at 35 to 50 falses that happen from 35 to 42 are usually thrown falses meaning the target is not under the coil and can be taking care of by pinpointing or sweeping 90 degrees to the target .43 to 50 are falses that happen when directly on a target much stronger than the thrown false . You can see this when you get a false at 35 to 43 when you get on the target that's 6 inches away it well high tone false usually at 46 to 48 seems to be where they happen most . As you can see 1 to15 is at 1060 hz and 1 to 10 is disc because I don't want foil high toning .

Now the way I set up is to have that 47 to 50 at 75hz they come in low so I don't have to stop every time I hear a high tone in this area which cut's falsing in half . More time swinging than looking .I need 5 bins but only have 4 so I, am not looking for gold here that's the bin that gets disc out . You can also set up with 47 to 50 disc out from the bottom to the top and your iron bin 32 to 35 disc on the bottom then you can use all 4 bins and only have the iron disc out . The reason why from bottom to the top is falses happen above the 12 line all the time .

Well this get rid of falsing h22l no but half is better than some as in other patterns I run .Just to make sure you can only use this in ferrous coin because of where the coins id in this mode . I have seen no deference with it disc or left open between the two patterns but left open I know where the iron is . sube