Find's Treasure Forums
Welcome to Find's Treasure Forums, Guests!
You are viewing this forums as a guest which limits you to read only status.
Only registered members may post stories, questions, classifieds, reply to other posts, contact other members using built in messaging and use many other features found on these forums.
Why not register and join us today? It's free! (We don't share your email addresses with anyone.) We keep email addresses of our users to protect them and others from bad people posting things they shouldn't.
Click here to register!
Need Support Help?
Cannot log in?, click here to have new password emailed to you
Changed email? Forgot to update your account with new email address? Need assistance with something else?, click here to go to Find's Support Form and fill out the form.
Opening A Fisher 1225-X ?
- Thread starter Hotwire
- Start date
MarkCZ
Well-known member
Hotwire said:
At the rear of the control housing they're is two small screws next to the coil connector. Those screws Do Not on the connector to the housing! they hold the board assembly to the housing.
In other words, if you remove those two screws and push on the coil connector everything slides out the front.
When you slide it apart you do have to watch the wires to the speaker and charger jack. (at least on the other 1200 series).
Mark
My 1225-X had a similar problem. Remove the large nut from the coil wire plug-in and the washer, then remove the works from the front. Battery wires will unplug and the ground is clipped under the front screw. Note the ground screw that goes thru the shaft is longer than the other shaft screw.
Funny but I had to take mine apart last night for the same problem.
Funny but I had to take mine apart last night for the same problem.