There`s an old carnival ground that I have hunted for years and found more silver there than any one place I`ve ever hunted. I haven`t found any silver there in a long time. I purchased a 705 and a digger coil and did pull out four Wheaties and one nickel in a couple a trips. I have recently got an e-trac and want to go back to the field and hunt but have been trying to learn it a while before I go there because I don`t want to take it out and not find anything. I`ve been using just the factory coin mode and finding coins and jewelry, but nothing deep yet. Any suggestions on what to do with my limited knowledge of the e-trac. I`ve looked at the two tone ferrous set up and wondered if that`s what I should try. Thanks!
Find's Treasure Forums
Welcome to Find's Treasure Forums, Guests!
You are viewing this forums as a guest which limits you to read only status.
Only registered members may post stories, questions, classifieds, reply to other posts, contact other members using built in messaging and use many other features found on these forums.
Why not register and join us today? It's free! (We don't share your email addresses with anyone.) We keep email addresses of our users to protect them and others from bad people posting things they shouldn't.
Click here to register!
Need Support Help?
Cannot log in?, click here to have new password emailed to you
old carnival ground
- Thread starter tometusns
- Start date
When did they stop using the carnival ground?? If you have non-ferrous trash in the mix, 2 tone will drive you batty, unless you're willing to keep one eye glued to the screen. If it was say "pre-1940's", then you could sure use TTF. Otherwise, I'd just hunt with the E-Trac and concentrate on good 2-way signals.
NebTrac
NebTrac
