Curt_in_W.Mass
New member
Recently my 8x6 sef coil sent machine into constant overload,called Kellyco and no solution offered for repair.So sliced into casing where it enters coil and there is 2 large grey wires inside and noticed casing on both was broke just before entering coil,and the exposed copper wiring was touching together on each large grey wire....figure this is a grounding wire as seems to encapsule wires inside?..anyways this was making machine go into overload at constant signal....noticed whites coils have another piece attached to casing to help when wires are bent right at coil....so if you dont have same problem yet i would advise taking your own remedy to ease wire bending at coil....just a bit of help to pass along....if not already mentioned.