NOISE CANCEL CHANNEL

[MINELABBOB]

HAS ANYONE
found that there CTX likes a special channel
mine likes 6# not all that important but like some feed back

THANKS MINELABBOB

 

[sube]

The # 1 channel has the lowest freq witch is best for high conductors # 11 channel has the highest freq witch is best for low conductors . There really is not much difference but some . sube

 

[MINELABBOB]

JUST WONDERING
what no# your CTX like the most??

 

[sube]

I seem to find more in channel 11 and think I get a little more depth however channel 1 should be deepest on high conductors as it is the lowest freq the detector will operate at . sube

 

[MINELABBOB]

OK SUBE
i will do some experments to see, but my CTX LIKES CH. 6# dont know why yet!!

 

[Digger]

Noise Cancel shifts the CTX's operating frequencies to reduce the effect of environmental electromagnetic noise. Environmental noise can be created by power lines, electrical equipment, cell phone towers and other metal detectors. With these environmental noises varying from site to site, your "favorite" noise cancel channel will quite likely vary from site to site as well. The important thing to remember when adjusting your NC is to keep the coil parallel to the surface of the ground. JMHO HH Randy

 

[Vez]

The parks I frequent, I can almost always count on the machine to put itself in 6 at one and 9 at the other.

 

[MINELABBOB]

YA VEZ
mine works in that range 6-9 and on some iron ground 2-3 but not to often

thanks 4 the info guys!!!!!!!

 

[MINELABBOB]

SUBE THAT IS TO MUCH
need to be a raido geek to understand all of that. but thats there job !! i still dont understand why if hrz run from 1.5-100 hrz.
it wont hit SM. gold chains good. i know single frequencys slam SM. gold chains one i will say MXT PRO WITH 5IN. COIL slamed
SM.gold chains better than the G-2 all to confusing!!

thanks

MINELABBOB

 

[sube]

Yea that is a mouth full I to don't understand half of it but it's there to read lol . sube