More silver from the Field with the XLT !

[Mark7]

Was able to get out Saturday evening for a bit,Came away with a 1937 Merc,two Wheaties Two memorial and a few clad.
Now today Sunday was a awesome day . Got a hat trick on the silver coins.Barber Dime (second one at this new spot) A merc, Washington Quarter four wheat's a memorial and a few clad.OH and the silver ring marked .925.
There is the normal trash also but I do not consider this spot a trash laden place.
This Field is turning into a very nice place to hunt.I have found silver each of the four days I have been here ,It is Ten minutes away behind my friends house and I do not believe it has been hunted before
I am just quickly going over the field right now with a modified c/j program and the stock 950 coil to cover ground and almost thru to whole field and then I am going to put on the Bulls eye 5.3 and hunt it hard. I feel there is a lot to find here over time.
I am hoping to get back out tomorrow for a few hours after work.

What a wonderful enjoyable hobby this is!

 

[MattBullSummerville]

Well you are killing it with the stock coil on that XLT . Keep over lapping tight, and doing what you are doing. Way to go on those wonderful finds!

 

[calabash digger]

nice finds!

 

[minelabking]

Great job...Good to see the the xlt still pulling them silver out the ground

 

[Dang]

Thats cool! virgin grounds!
Did you first begin hunting there with the reloaded programs or right away with the mods?
Just curious. I'm a XLT rookie myself and have hardly used it yet. Been using the preloaded programs
as suggested for beginners.

 

[Texan]

My favorite coil when I had an xlt was the 800. Still have it and wished it would work on the v3i

 

[Mark7]

I go right to my modified c/j program every time I go out. I change a few settings on it depending on were I am hunting. I normally only change A/C & D/C sensitivity pre amp gain, bottle cap reject,recovery speed. Sometimes I use mix mod,I all ways use tone Id,vco,Volume at max I am halfway deaf from all the equipment I ran in my younger days. I do fool around with other setting once in a while. like to just go out and hunt,On that note I have not been able to get back to the field for several weeks now. I was rear ended by a loaded dump truck and I am having problems with my back and leg pain
quote=Dang]
Thats cool! virgin grounds!
Did you first begin hunting there with the reloaded programs or right away with the mods?
Just curious. I'm a XLT rookie myself and have hardly used it yet. Been using the preloaded programs
as suggested for beginners.[/quote]

 

[Mark7]

My favorite coil when I had an xlt was the 800. Still have it and wished it would work on the v3i

I use the stock 950 coil first and then go over everything again slower with the bullseye 5.3. I am happy for the most part with my results so far. Eventually I am going to get another whites detector I just not sure which way to go yet. I am still having fun with the XLT so I am in no hurry.