minelab repair service question help needed

[Anonymous]

sent my exp.xs back to minelab for a brokenheadphone jack,got it back within a week and a half all repaired,while they had it they also replaced the housing to rep[air the minor crack on the upper camlock (they did this on there own) well when i got the unit back the black padding on the handle grip was gone can anyone recommend a good way for me to remedy this problem? i wrote mark an email and asked him to send the item out to me can antone recommend a temporary fix? thanks Robert in wisc.

 

[Anonymous]

Just run a few wraps of duct tape around it if you think you need a grip on the handle, or just use it without.. some of us replaced the factory grip with cold shrink, but dont ask me where you can get it, one of the guys sent it to me

 

[Anonymous]

Hi there,I am a very recent owner of an Explorer
and I have used some crepe bandage around mine.
In a few months time I can do it again as necessary.
It is also better to hold in this hot summer weather.
Happy Hunting,
Jerry.

 

[Anonymous]

The wrap that they use for tennis grips should work well. I used this wrap on my shotgun grip when I was shooting a lot of trap. It helped asorb a lot of the shock.