Find's Treasure Forums
Welcome to Find's Treasure Forums, Guests!
You are viewing this forums as a guest which limits you to read only status.
Only registered members may post stories, questions, classifieds, reply to other posts, contact other members using built in messaging and use many other features found on these forums.
Why not register and join us today? It's free! (We don't share your email addresses with anyone.) We keep email addresses of our users to protect them and others from bad people posting things they shouldn't.
Click here to register!
Need Support Help?
Cannot log in?, click here to have new password emailed to you
Minelab Excalibur seals
- Thread starter Waterdog
- Start date
Go to "oldbeechnut" youtube site, you will find everything you need there or just search for his post on here or the internet.
OBN YouTube
OBN YouTube
OldBeechnut
Well-known member
http://www.findmall.com/read.php?22,1437544,1489695#msg-1489695
Just started using the Red Silicon, some very sure seal O-Rings, almost to soft. they tear easy, but there are a few little secrets...Endcap install, put set screws in just flush with inside of pod, then a very small amout of silicon to fill any sharp edges, let dry. Then install the Red's on the endcaps, silicon grease the Oring, and slide in...hold in place for about 30 seconds..then tighten the set screws.
For anyone just starting, I would reco EPDM's from McmasterCarr
Just started using the Red Silicon, some very sure seal O-Rings, almost to soft. they tear easy, but there are a few little secrets...Endcap install, put set screws in just flush with inside of pod, then a very small amout of silicon to fill any sharp edges, let dry. Then install the Red's on the endcaps, silicon grease the Oring, and slide in...hold in place for about 30 seconds..then tighten the set screws.
For anyone just starting, I would reco EPDM's from McmasterCarr