Menu
What's new
Find's Treasure Forums

Welcome to Find's Treasure Forums, Guests!

You are viewing this forums as a guest which limits you to read only status.

Only registered members may post stories, questions, classifieds, reply to other posts, contact other members using built in messaging and use many other features found on these forums.

Why not register and join us today? It's free! (We don't share your email addresses with anyone.) We keep email addresses of our users to protect them and others from bad people posting things they shouldn't.

Click here to register!

Need Support Help?

Cannot log in?, click here to have new password emailed to you

Makro Racer 2 Overloading / LO Battery?

F

Fish_in_1

New member
New to the detector and haven't seen any post on this here, but yesterday went out to do some detecting and learning at the same time.. I was dealing with metal screw off bottle tops and when I went to the pin point mode it would overload as long as they were with in 3" away, I know this would or should be normal.. My question is though when it would over load in pin point if I used the pinpoint mode while overloading for more then 1 sec it would show LO Battery and wouldn't return to any detecting mode unless I turned it off and back on then the battery would return to full power, was a new set of energizers.
Any thoughts???Normal???...hope not!!Thanks in advance!
 
Some of the early production Racer 2's, not all of them, did have that issue. I know I did with one of mine and I have heard of a couple of others. If you bought it used and have the original purchase paperwork, then send an e-mail to Dilek and ask her what can be done.

Monte
 
You must log in or register to reply here.
Top