Looking for a V mounting clip for a Sovereign meter.

[Treasurechic]

Treasurechic submitted a new listing:

Looking for a V mounting clip for a Sovereign meter. - Looking for a V mounting clip for a Sovereign meter.

I am in need of a Black V mounting clip that the Minelab Sovereign meter slides onto. I purchased a new upper rod and was told that it had one and when it showed up today no clip on it. Let me know if you have one and how much. Please include a picture.

Learn more about this listing...

 

[South Padre Treasure]

I have one on my GT, I do not use a meter. Your welcome to have it. No charge just pm me with your shipping address.

 

[Treasurechic]

I have one on my GT, I do not use a meter. Your welcome to have it. No charge just pm me with your shipping address.

This is what I need: look at figure #4

 

[Desi Dunne]

Did you get hooked up from South Padre....???

 

[Treasurechic]

Did you get hooked up from South Padre....???

Sure did. Thanks Desi!

 

[Treasurechic]

Found one!!!!!

 

[Desi Dunne]

"I found one like still attached to a shaft so I'd need to drill it out and it could break!

So you're good to go so huh???"

 

[Rick(ND)]

Found one!!!!!

Use a small drill bit as you only have to drill out the very center of the rivet as that is what is holding it on the shaft. Then just rivet it back on your shaft so the meter will slide in place as small screw wont work. be careful and not mount it upside down like I have done a couple of times.
Good luck and hope to see the finds you will find.

 

[Treasurechic]

Thank you!

 

[Treasurechic]

"I found one like still attached to a shaft so I'd need to drill it out and it could break!

So you're good to go so huh???"

Yes Desi. I am in good shape. I will post before and after photos of the GT. On the forum when I get it done.