Length of Impact coil cable?

[pine3874]

How long is the Impact coil cable in inches? Want to see if it is long enough to use with my Kruzer. Thanks

 

[BigTony]

I think they spoke about this on the other forum a few weeks ago.

Check there because I think some use the Impact coils on a Kruzer but not the reverse.

 

[Monte]

the Nokta Impact coils are not going to work well for you on a Makro Kruzer or Multi-Kruzer. They are simply too short. I kind of stand about 5' 11" or so and somewhat bent forward with my cane and after getting a Multi-Kruzer I tried my 5" DD, 5X9½ DD and 7" Concentric Impact coils on the multi-Kruzer to evaluate their performance. They either had a straight reach from coil to connector or just barely one wrap around the rod. If I stood erect at my former 6' height [size=small](this shrinking with age in annoying)[/size] they would not have worked, and even evaluating the Multi-Kruzer with my Impact coils it was not always a nice and proper fit.

So I just enjoy using my Impact with it's coils and regard the Kruzer as needing the coils made for it with proper-length cables.

Monte

 

[pine3874]

I appreciate the replies, but if someone could find a minute to actually measure the length of the cable, that would be very helpful to me in deciding if the cable is long enough to be used on my Kruzer. I have the lower rod of my Kruzer set in the third hole down from the upper camlock, so if the cable is 30 inches or longer, that will work for me. Thanks

 

[BigTony]

n/t

 

[pine3874]

n/t

 

[BigTony]

n/t