Is it possible to speed up the fade rate in analize mode?

[Rattlehead]

Hi guys,
I've noticed that when I switch to analize mode (sizing) and scan a target that the info stays on the screen, even after I sweep it again. Is it possible to set the fade rate faster for this screen, or set it up so that it updates with every new sweep?

Thanks!

 

[ak_1234]

Short answer is no. The analyze mode captures all the data in a sweep before it displays it. The only way it knows when a sweep is done is if there was a target, and then there is no signal for a given amount of time. If you are getting constant targets, it will not have a chance to display. You could pull and release the trigger between sweeps. It is not a continuous search mode - it is for when you find a target and you want to get more info on that one target - sweep over the target that once (sometimes 2ce) and see the display.

 

[Rattlehead]

Thanks for the info AK. I'll just have to stick with the way I've been doing it then, which is pulling the trigger between sweeps like you mentioned.

Thanks again!

 

[Rob (IL)]

Thanks for all the posts Anne.

 

[Larry (IL)]

If you wait two seconds between sweeps, the analyze screen should reset with the new data collected on the return swing.

 

[Rattlehead]

I didn't know that Larry. Thanks to all of you for the info.