I need your Ideas and or Pictures for Loop Supports.

[goodmore]

Crazyman said it best about that little plastic bolt. I can't tighten it enough to keep a wave from flopping the coil. I need a loop support that doesn't cost 15.00 at a detector on line store.

I

 

[GraveDiggerMax-VaBch-Va]

some years back, there were several posts about using dremel cut off wheels...............had to drill out center hole to 1/4".............suppose to work good, never tried, but i have some.
.
.
.
.
[attachment 171016 dremelcutoff.jpg]
.
.
.
several years ago when i used the wot on a certain GT i had in those days, i made one of these from plastic barrel, worked great
.
.
.
.

.

here is a pic of the one u are talking about

 

[Buried Crap NJ]

Max how do you like the BHID? Any tips on tuning it for the beach/ wet sand / water? I have been forced to use one as my New Excal gets fixed! steve Jersey shore beach hunters

 

[GraveDiggerMax-VaBch-Va]

Not me............not in a million years

where did u get that from............? i know several guys that use and love them and really do G O O D with them, but i have never had one.

 

[Buried Crap NJ]

Oh I though the last picture was the coil from one. My mistake.

 

[erikk]

Cut a chunk out of wife's old nylon cutting board works like a champ I have them on my excals and BH300

 

[erikk]

Max how do you like the BHID? Any tips on tuning it for the beach/ wet sand / water? I have been forced to use one as my New Excal gets fixed! steve Jersey shore beach hunters

If U use the side mount loop support Kellyco or the like) on the BH300 or any of the White coils that have the thin flimsy ears they do have a tendency to snap off I know of 3 personally that it happened 2

 

[GraveDiggerMax-VaBch-Va]

n/t

 

[plugger]

n/t

 

[plugger]

n/t

 

[ivanll]

This works for me, have done the job for many years.

ivanll

 

[ivanll]

I favor the Nitrile.

ivanll

 

[erikk]

n/t

Sure I can....

 

[erikk]

??????????????

 

[synthnut]

ivanil ,
That's a prettt slick setup there !!!.....Jim