How to turn F75 into silver u max

[gmanlight]

A silver u on ROIDS that is. Read a very " intelligent " post-er today about using mono 1 tone on F75 just like my silver u and like the tesoro line there is a

differents in a clean beep and a scratchy beep. I put a rusty 2.5in nail above a nickle with 1in between on the floor in my house with many nails in sub floor

Turned disc and notch to 1 sens way down with large coil using multi tones if swung top to bottom #s bounce but tones works because of processor speed

If swung left to right u might get a hi tone pop but low tone over load will take over and u walk right by

Now if in mono swing left to right #s still all over but a scratchy beep tells somethings there then turn body beep is clear. Time to dig

? How do i cut plug out of living room carpet Cant wait to try this outside

 

[tmanfromtexas]

Just curious, why not just run in all metal mode especially if you are turning the notch to 1. Just curious. TMAN...

 

[gmanlight]

TMAN the point was for testing only If working in a lot of small iron with 4 tones or others a good target near iron can get tone overload

and humans cant process them fast enough and VID will not help cause #s will bounce around try it

Using 1 tone u can lock on bad tone and rotate around to find good target

This was proposed by NASA TOM i just put it here for others to see

 

[tmanfromtexas]

Thanks Gman for the info. Since it looks like it will rain here until noon, I will try this out and see what I can learn. TMAN...