Kelley (Texas)
New member
After reading about various methods used to clean coins, I decided to see how using electrolysis would work. I had never used electrolysis before because I had always been of the opinion that it was too complicated...even the word "electrolysis" itself put fear in me. After reading several articles on Google Search, I decided to give it a try.
You will need the following:
1. Alligator clips
2. 9 volt battery connector
3. 9 volt battery
4. stainless steel spoon or fork
5. tea spoon of table salt
6. three or four drops of lemon juice
7. a small drinking glass
8. baking soda
I went to Radio Shack and purchased some alligator clips, a 9 volt battery connector, and a 9 volt battery. I soldered the alligator clips to the battery connector...the only actual work that you have to do. This is how it looked after being soldered.
[attachment 16449 electrolysiskit2.jpg]
I filled the glass with water, then added a tea spoon of table salt, and four drops of lemon juice...then stirred the mixture.
I then put a stainless steel spoon in the water and connected the red positive alligator clip to the spoon. Then I connected the black negative alligator clip to the dirty coin and dropped it into the water while making sure that the coin did not touch the spoon. finally, I put the battery connector on the battery.
Picture of the coin before cleaning.
[attachment 16450 coinbefore2.jpg]
When I connected the battery connector to the battery, almost immediately I noticed bubbles surrounding the coin. I watched the water turn dirty for the next several minutes. I lifted the coin out of the water several times to check the cleaning process. After a few minutes, the coin was clean.
I removed the coin from the water and ran some water on it, then polished it with baking soda. The baking soda will also stop any further corrosion of the coin.
Picture of the coin after cleaning.
[attachment 16451 cleancoin3.jpg]
The cleaned coin did have a slight copper colored tone which may have been caused by the alligator clips possibly having copper in the metal. I would suggest using a good pair of stainless steel alligator clips. You must remember that this is the first time that I have ever used electrolysis, so I still have lots to learn. I hope this will help some of you in cleaning some of your coins found while metal detecting. Kelley (Texas)
NOTE: I would not suggest using this method to clean rare or valuable coins until you have researched this method of cleaning coins.
You will need the following:
1. Alligator clips
2. 9 volt battery connector
3. 9 volt battery
4. stainless steel spoon or fork
5. tea spoon of table salt
6. three or four drops of lemon juice
7. a small drinking glass
8. baking soda
I went to Radio Shack and purchased some alligator clips, a 9 volt battery connector, and a 9 volt battery. I soldered the alligator clips to the battery connector...the only actual work that you have to do. This is how it looked after being soldered.
[attachment 16449 electrolysiskit2.jpg]
I filled the glass with water, then added a tea spoon of table salt, and four drops of lemon juice...then stirred the mixture.
I then put a stainless steel spoon in the water and connected the red positive alligator clip to the spoon. Then I connected the black negative alligator clip to the dirty coin and dropped it into the water while making sure that the coin did not touch the spoon. finally, I put the battery connector on the battery.
Picture of the coin before cleaning.
[attachment 16450 coinbefore2.jpg]
When I connected the battery connector to the battery, almost immediately I noticed bubbles surrounding the coin. I watched the water turn dirty for the next several minutes. I lifted the coin out of the water several times to check the cleaning process. After a few minutes, the coin was clean.
I removed the coin from the water and ran some water on it, then polished it with baking soda. The baking soda will also stop any further corrosion of the coin.
Picture of the coin after cleaning.
[attachment 16451 cleancoin3.jpg]
The cleaned coin did have a slight copper colored tone which may have been caused by the alligator clips possibly having copper in the metal. I would suggest using a good pair of stainless steel alligator clips. You must remember that this is the first time that I have ever used electrolysis, so I still have lots to learn. I hope this will help some of you in cleaning some of your coins found while metal detecting. Kelley (Texas)
NOTE: I would not suggest using this method to clean rare or valuable coins until you have researched this method of cleaning coins.