king-ghidorah
New member
I got this off of goldminingcentreDOT com. Has anyone utilized this method. First time I have heard of it.
"Other procedures to fully utilize the Infinium LS discrimination are as follows. When a target is detected, take note of the tone you are getting first. Then move only the front toe of the coil over the target and check the target response tone. You will quite often find that a target may be giving a high or low tone first, but by using the front toe of the coil, this tone will change. I have found this discrimination test a more accurate way of determining a targets conductivity. Sometimes a plated bit of steel will give a high tone, but by using the toe of the coil, it will change to a low tone, indicating that it is more likely to be steel. Then use the reverse discrimination to confirm the targets possible identity."
"Other procedures to fully utilize the Infinium LS discrimination are as follows. When a target is detected, take note of the tone you are getting first. Then move only the front toe of the coil over the target and check the target response tone. You will quite often find that a target may be giving a high or low tone first, but by using the front toe of the coil, this tone will change. I have found this discrimination test a more accurate way of determining a targets conductivity. Sometimes a plated bit of steel will give a high tone, but by using the toe of the coil, it will change to a low tone, indicating that it is more likely to be steel. Then use the reverse discrimination to confirm the targets possible identity."
but I can't recall where 
???
) on where I read this because there was more detailed info on it!
