Menu
What's new
Find's Treasure Forums

Welcome to Find's Treasure Forums, Guests!

You are viewing this forums as a guest which limits you to read only status.

Only registered members may post stories, questions, classifieds, reply to other posts, contact other members using built in messaging and use many other features found on these forums.

Why not register and join us today? It's free! (We don't share your email addresses with anyone.) We keep email addresses of our users to protect them and others from bad people posting things they shouldn't.

Click here to register!

Need Support Help?

Cannot log in?, click here to have new password emailed to you

Changed email? Forgot to update your account with new email address? Need assistance with something else?, click here to go to Find's Support Form and fill out the form.

fisher gold strike schematic PLEASE HELP

M

machine744014

New member
So I talked to a tech. guy who works at fisher in Texas. He could not find the schematic for the gold strike. He was able to give me 3 pin codes, I need 5. 5 wires goes off the circuit board and to a 5
pin switch craft connector numbered 1-5. 5 being in the middle. The cable that comes up from the coil that plugs into that connector, I opened it up a little to see if I could match the wires. No way. It some how turns into 2 wires that go into the coil. This would be so easy if I had the schematic for it. If fisher does not have it, Who does? Just need to know which color wires goes to the 5 pin connector in the control housing. Any advise will be helpful. Thank you.
 
machine744014 said:
So I talked to a tech. guy who works at fisher in Texas. He could not find the schematic for the gold strike. He was able to give me 3 pin codes, I need 5. 5 wires goes off the circuit board and to a 5
pin switch craft connector numbered 1-5. 5 being in the middle. The cable that comes up from the coil that plugs into that connector, I opened it up a little to see if I could match the wires. No way. It some how turns into 2 wires that go into the coil. This would be so easy if I had the schematic for it. If fisher does not have it, Who does? Just need to know which color wires goes to the 5 pin connector in the control housing. Any advise will be helpful. Thank you.
Click to expand...

Keith Wills at East Texas Detectors would have the wiring code, but be brief with him, get what you need, thank him and move on. His web site is brokendetectors dot com

As far as that fifth wire in the control housing number 5 will most likely just go to ground the connector housing body. The center pin on the coil connector isn't used, but its possible that if the center pin is connected in the control housing it could be for lab testing only.

The coil cable actually only has two wires in it,
A white wire with a braided shield.
A red wire with a braided shield. (all the modern coil cables that I've seen are the same, this combination gives them four separate wiring points)

I doubt very seriously that a person can figure out how to wire the connector on the coil by looking at anything on the inside of the control housing, wire colors are probably not the same.

If the wiring for the C$ coil didn't work then I'm going to say that Keith would be your next best bet, or hit another forum and try to find somebody else with a Gold Strike.

Are you needing the wiring for the connector on the coil, or for the connector in the control housing?

Mark
 
I've tried to follow topics on here for the Coinstrike and the Gold Strike, to be honest I'm not sure there is any Gold Strike owners on here? (there could be)

Mark
 
You must log in or register to reply here.
Top