F 75 Numbers ID ?

[gmanlight]

Hi 75Er's just got mine,never had a # id just tone I have seen ID F 75 value chart

How much bounce could you see on deeper coin targets

It was right on with shallow hits Did get a lot of bounce in trashy spot but that was me being blockhead and not using small coil

Thanks Mike

 

[EZrider]

Mike, it depends on alot of things. How deep? Did you move your body around the target while swinging short strokes over it? What were your settings? Coins will only bounce a couple of numbers if tilted. If the numbers were wide it maybe trash. Best advice is to grit your teeth, use the factory settings then make sure you ground balance. Get a good 30 hours behind it and dig all high signals. A 5 gallon pail of caps and tabs, iron later i got the hang of what its telling me. Im still learning.

 

[Sunny Jim]

Hey Mike!

Congrats on the new machine!

"Coins will only bounce a couple of numbers if tilted. If the numbers were wide it maybe trash."

That is some good advise EZ, worthy of being a well published tip along with the rule of 6.

Thanks

Sunny Jim

PS: Saved this tip to file
SJ

 

[gmanlight]

Thanks guys i never had a meter before i will use small coil with your tips big coil saw to many targets other than that it was smooth