Menu
What's new
Find's Treasure Forums

Welcome to Find's Treasure Forums, Guests!

You are viewing this forums as a guest which limits you to read only status.

Only registered members may post stories, questions, classifieds, reply to other posts, contact other members using built in messaging and use many other features found on these forums.

Why not register and join us today? It's free! (We don't share your email addresses with anyone.) We keep email addresses of our users to protect them and others from bad people posting things they shouldn't.

Click here to register!

Need Support Help?

Cannot log in?, click here to have new password emailed to you

Changed email? Forgot to update your account with new email address? Need assistance with something else?, click here to go to Find's Support Form and fill out the form.

explorer display

A

Anonymous

Guest
My display on my explorer in smart mode or digital will take a long time to move the cross hairs.
I can pass the coil over a target and the tone will indicate the cross hairs should be down low, but they stay at the last target location. I sweep the coil over the target several times getting the same tone then after 3 to 4 sweeps the cross hairs will then move to the general area where I thing they should be. It does not matter if I swing the coil slow or fast. I Have had this piece of equipment for about 3 weeks, and I don't think that it used to take so long. It doesn't seem to mater if the factory settings are used or not. Is this correct for the explorer, or is my unit starting to get a little flaky?
Thanks,
Cliff
 
they do react slow sometimes, especially if near trash, iron or something disced out. If you notice the crosshairs dont move till the threshold returns, so if theres nulling nearby they wont move.. In those situations I generally try going over the target a few times and lift the coil up away from the ground immediately after the target stops signaling to get a reading...
 
You must log in or register to reply here.
Top