Excalibur remote p/point - Sov GT pot values

[tractorman]

Need directions for wiring remote P/point into Excalibur. Have to change out threshold pot and want to run wiring while it is open. Am turning new endcaps on lathe so out the end is no issue. Also need sov gt pot values if anyone can help, I'm a machinest and am rebuilding sov into surfproof alum case with some mods. With all the knowledge on this board, I'm sure there is help out there. Thank's in advance, Tractorman.

 

[bountyhunter1972]

You might want to try the Geotech.com forums they will have answer for you too.

 

[Sven]

Need directions for wiring remote P/point into Excalibur. Have to change out threshold pot and want to run wiring while it is open. Am turning new endcaps on lathe so out the end is no issue. Also need sov gt pot values if anyone can help, I'm a machinest and am rebuilding sov into surfproof alum case with some mods. With all the knowledge on this board, I'm sure there is help out there. Thank's in advance, Tractorman.

Pot values are marked on the back of most pots example:
10k ohms, 100k ohms
http://sound.westhost.com/pots.htm