sflsweeper
New member
Hello all,
This is not going to be bang its fixed I am sure, but while on the beach today with a brand new charge on my battery pack my excal left me with no tone control with threshold. With threshold all the way on no tone, machine would still find targets but not very efficiently. About 10 minutes into my hunt tone came back and I had to lower my threshold but the machine would freek out like it had a bad battery charge about once every 5 minutes but the battery is fully charged and I tried my backup pack with the same results.
I did notice a little wear in my batter connector where the wire is inserted into it but other than that I do not know what the issue could be. Could the connector be corroded inside? I am hoping I do not have to send this back to minelab as I know they will take months get me my machine back. Any help would be greatly appreciated.
This is not going to be bang its fixed I am sure, but while on the beach today with a brand new charge on my battery pack my excal left me with no tone control with threshold. With threshold all the way on no tone, machine would still find targets but not very efficiently. About 10 minutes into my hunt tone came back and I had to lower my threshold but the machine would freek out like it had a bad battery charge about once every 5 minutes but the battery is fully charged and I tried my backup pack with the same results.
I did notice a little wear in my batter connector where the wire is inserted into it but other than that I do not know what the issue could be. Could the connector be corroded inside? I am hoping I do not have to send this back to minelab as I know they will take months get me my machine back. Any help would be greatly appreciated.