Menu
What's new
Find's Treasure Forums

Welcome to Find's Treasure Forums, Guests!

You are viewing this forums as a guest which limits you to read only status.

Only registered members may post stories, questions, classifieds, reply to other posts, contact other members using built in messaging and use many other features found on these forums.

Why not register and join us today? It's free! (We don't share your email addresses with anyone.) We keep email addresses of our users to protect them and others from bad people posting things they shouldn't.

Click here to register!

Need Support Help?

Cannot log in?, click here to have new password emailed to you

Changed email? Forgot to update your account with new email address? Need assistance with something else?, click here to go to Find's Support Form and fill out the form.

E-Trac upper rod modification

J

Josh(ND)

New member
Have srren some guys cut a hole in the upper shaft to allow the coil cable to still be run up the shafts when using a Sunray pinpointer. Question #1 did u loose any strenght by doing it and #2 If you could or would do it again would you do it differently. Thanks Guys Josh
 
I did mine and would do it again, i don't think i lost any strength(noticable anyway), rather than a round hole i made an elongated hole so the conector comes out easier when changing coils. The only drawback is that the lower rod won't close as it does without the sunray fitted so its a bit longer when stored.
 
You must log in or register to reply here.
Top