Deep Silver Program -After the Cherry Picking?

[gmhowerton]

I was wondering if anyone had a Deep Silver Program that they've had success with... I want to go over a couple of trashy parks and school yards that have been searched practically to extinction to find any remaining silver... I want to notch out anything that didn't fall into the silver range...

 

[HuntinDog]

Some say Notching out everything can effect depth.
Good targets masked by other junk will have their numbers pulled down and into your notched zones and thereby be missed.
I've been running my Deus in Full Tones with Calabashdiggers Sifter program and listening carefully to the tones.
CZconnoisseur does very well in trash. Not sure what his program is, but I know he digs it all and finds are great.
I'm still learning how the masked targets sound, but it's getting better and finds are increasing.

 

[CZconnoisseur]

Try these: http://www.findmall.com/read.php?83,2337462

4Khz is used to ignore the small aluminum targets - but it's not infallible!

 

[calabash digger]

that sifter program is Garys and remember its not a deep seeking program. My relic programs are the deep ones I use mainly and only use the sifter for special circumstances.

 

[squirrel1]

Notch on Deus,,,,using it can help you here,,,,but you just don't notch out targets by exact vdi,,,,you have to go higher.
This will not get some silver or higher conductors though.

You need to be thinking,,,average TID here,,,,,,leaver the lower meter vdi stuff alone,,,watch for mid level meter readings,,,,,tab near coin for example.

You can also notch out 00-90 and have a run,,,,you won't hear much tonally,,,deeper should come through.
Experiment with different freqs.

When you do get a mid level TID target reporting in,,,,walk a circle around it while,sweeping,,,see any monetary spikes of TID number?? If yes dig it out.

Try and be able to tell,,,,,using all means possible,,,is a target that is being tonally reported,,,,,is it a solo target or a nonferrous combined set of targets..

Also,,,,you might consider digging what I call challenged only targets with iron and nails,,,,these likely will have meter read is between 00-07 on the meter,,,even if running 0 Sid.

Lots of ways to approach and do.

Use the Deus detector tendencies,,,key on them,,make them work for you.

 

[gmhowerton]

Thanks... I tried a program that I found online which basically incorporated your ideas and I had immediate success... I went to a school site that had been built over land where old houses once were. I spent about two hours searching and found a 1945 Washington quarter and a Sterling Silver ring, basically a wedding band, along with about 7-8 other quarters, several dimes and lots of pennies, including one Wheat cent.

The program settings were based on frequency 4 and notching out 0-60 and 95-99... Worked as expected and made the hunting fun in a very trashy area...


I had previously hunted this school using the Sifter program, which I do like, but this program allowed less trash thru... Probably kept some good targets out too, but still, it was fun to use and I had some good success...